Enterasys RoamAbout RBT-4102 - Using the CLI to Upgrade Firmware

Administration
RoamAbout RBT-4102 Wireless Access Point Configuration Guide 4-43
Using the CLI to Upgrade Firmware
TodownloadsoftwarefromaTFTP/FTPServer,usethecopycommandfromtheExecutivemode.
Thecopycommandrequiresyoutospecifyeitherthefiletypeandthentheservertype,orthe
servertypeandthenthefiletype.Youmustthenspecifythefilename,andIPaddressof
theTFTP
server.Whenthedownloadiscomplete,youcanusethedircommandtocheckthatthenewfileis
presentintheaccesspointfilesystem.Torunthenewsoftware,usetheresetboardcommandto
reboottheaccesspoint.
Example
RoamAbout 4102#
RoamAbout 4102#copy tftp file
1. Application image
2. Config file
3. Boot block image
Select the type of download<1,2,3>: [1]:1
TFTP Source file name:ets-img_v1017.bin
TFTP Server IP:10.120.112.2
Firmware version of system is V1.0.16 and Updating Run-Time code v01.00.17 NOW!
This firmware is compatible with hardware.
The software was properly copied over to the system and a reset is needed in order
for the software changes to take place.
RoamAbout 4102#