Enterasys RoamAbout RBT-4102 - Using the CLI to View WDS-STP Status; Show Bridge

Status Information
RoamAbout RBT-4102 Wireless Access Point Configuration Guide 4-105
Using the CLI to View WDS-STP Status
Toviewthe status informationshownintheWDS‐STPStatuswebpage,youwillneedtoenter
severalcommands.Thissectionbreaksupthecommandsthatyouwillneedtoshowcomplete
screenexamples.
Allexamplesdisplaythechoicesavailableforthecommands.
show bridge
ThefollowingexampleusestheshowbridgecommandfromtheExecutivemodetodisplaythe
STPparameters
Example
RoamAbout 4102#sho bridge ?
aging-time Show dynamic entry aging time
filter-entry Show the MAC entry in filter database
link Show parameters of each link/port
STP Show Spanning Tree parameters
RoamAbout 4102#sho bridge STP
Bridge MAC : 00:11:88:06:37:35
Status : Enabled
priority : 32768
desiginated-root : priority = 32768, MAC = 00:11:88:06:2F:B4
root-path-cost : 19
root-Port-no : 19
Hold Time : 1 Seconds
Hello Time : 2 Seconds
Maximum Age : 20 Seconds
Forward Delay : 15 Seconds
bridge Hello Time : 2 Seconds
bridge Maximum Age : 20 Seconds
bridge Forward Delay : 15 Seconds
time-since-top-change: 19081 Seconds
topology-change-count: 26