Enterasys RoamAbout RBT-4102 - Using the CLI to Configure WPA2 Security

Security
RoamAbout RBT-4102 Wireless Access Point Configuration Guide 4-91
Default Transmit Key : 1
Common Static Keys : Key 1: ***** Key 2: EMPTY
Key 3: EMPTY Key 4: EMPTY
Pre-Authentication : Disabled
Authentication Type : OPEN
----------------Authentication Parameters----------------
802.1X : REQUIRED
Broadcast Key Refresh Rate : 0 min
Session Key Refresh Rate : 0 min
802.1X Session Timeout Value : 60 min
=========================================================
RoamAbout 4102#
Using the CLI to Configure WPA2 Security
Fromtheinterfacewirelessorinterfacewireless:VAPconfigurationmodes,usethe
authenticationcommandtoselectthewpa2requiredauthentication.
Examples
RoamAbout 4102(config)#interface wireless g
Enter Wireless configuration commands, one per line.
RoamAbout 4102(if-wireless g)#authentication wpa2 required
Data Encryption is set to Enabled.
WPA Clients Mode is set to Disabled.
WPA2 Clients Mode is set to Required.
WPA2 Multicast Cipher is set to AES-CCMP.
WPA2 Unicast Ciphers can accept AES-CCMP only.
WPA2 Authentication is set to 802.1X Required.
RoamAbout 4102(if-wireless g)#exit
RoamAbout 4102#
Todisplaythecurrentsettings,usetheshowinterfacewirelessaortheshowinterfacewirelessg
commandfromtheExecutivemode.
RoamAbout 4102#sho int wire g
Wireless Interface Information
=========================================================
----------------Identification---------------------------
Description : "RD-AP4102"
SSID : r&d
802.11g band : 802.11g only
Channel : 8 (AUTO)
Status : Disable
----------------Antenna----------------------------------
Antenna Select : Fixed
Fixed Antenna Control : Diversity
Antenna ID : 0x0000(Integrated antenna)
Ack-TimeOut : 0 us
----------------802.11 Parameters------------------------
Transmit Power : FULL (17 dBm)
Max Station Data Rate : 6Mbps
Multicast Data Rate : 1Mbps
Fragmentation Threshold : 512 bytes
RTS Threshold : 256 bytes
Beacon Interval : 150 TUs