Enterasys RoamAbout RBT-4102 - Using the CLI to Display CDP Status

Status Information
RoamAbout RBT-4102 Wireless Access Point Configuration Guide 4-99
Using the CLI to Display CDP Status
Usethecdpenableorcdpauto‐enablecommandsfromthegeneralconfigurationmodetoenable
theAPtouseCDP.SetCDPparametersusingthecdphold‐time,cdptx‐frequency,andcdp
authenticationcommands.ToviewthecurrentCDPsettings,usetheshowcdpcommandfrom
theExecutive
mode.
Example
RoamAbout 4102#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 4102(config)#cdp auto-enable
RoamAbout 4102(config)#cdp hold-time 300
RoamAbout 4102(config)#cdp authentication asdfg
RoamAbout 4102(config)#cdp tx-frequency 120
RoamAbout 4102(config)#exit
RoamAbout 4102#show cdp
CDP Global Information
========================================
Global Status : Auto Enable
Authentication Code : asdfg
Transmit Frequency : 120 secs
Hold Time : 300 secs
========================================
RoamAbout 4102#