Enterasys RoamAbout RBT-4102 - SSH Configuration

TCP / IP Settings
RoamAbout RBT-4102 Wireless Access Point Configuration Guide 4-9
SSH Configuration
ToenabletheSSHserver,usetheipssh‐serverenablecommandfromtheCLIEthernetinterface
configurationmode.TosettheSSHserverUDPport,usetheipssh‐serverportcommand.To
disabletheTelnetserver,usethenoiptelnet‐servercommand.Toviewthecurrentsettings,use

theshowsystemcommandfromtheCLIExecutivemode(notshowninthefollowingexample).
Example
RoamAbout 4102#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 4102(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
RoamAbout 4102(if-ethernet)# ip-ssh-server enable
RoamAbout 4102(if-ethernet)# ip-ssh-server port 1124
RoamAbout 4102(if-ethernet)# no ip telnet-server