Enterasys RoamAbout RBT-4102 - Using the CLI to Configure WPA Pre-Shared Key; Using the CLI to Configure WPA over 802.1 X Security

Security
4-82 Advanced Configuration
Using the CLI to Configure WPA Pre-Shared Key
Toenterakeyvalue,usethewpa‐psk‐typecommandtospecifyahexadecimaloralphanumeric
key,andthenusethewpa‐preshared‐keycommandtodefinethekey.Toviewthecurrentsecurity
settings,usetheshowinterfacewirelessaorshowinterfacewirelessgcommand(notshownin

example).
Example
RoamAbout 4102#configure
RoamAbout 4102(config)#no 802.1X
RoamAbout 4102(config)#interface wireless g
Enter Wireless configuration commands, one per line.
RoamAbout 4102(if-wireless g)#no 802.1x
WPA-Mode have been converted to preshare key
RoamAbout 4102(if-wireless g)#authentication open
RoamAbout 4102(if-wireless g)#authentication wpa-psk required
Data Encryption is set to Enabled.
WPA2 Clients Mode is set to Disabled.
WPA Clients Mode is set to Required.
WPA Multicast Cipher is set to TKIP.
WPA Unicast Ciphers can accept TKIP.
WPA Authentication is set to Pre-Shared Key.
RoamAbout 4102(if-wireless g)#wpa-pre pass agoodsecret
RoamAbout 4102(if-wireless g)#
Using the CLI to Configure WPA over 802.1X Security
Firstset802.1Xtorequiredusingthe802.1Xcommandandsetthe802.1Xkeyrefreshrates.Then,
fromthe802.11aor802.11ginterfaceconfigurationmode,usethevapcommandtoaccesseach
VAPinterfacetoconfigureothersecuritysettings.
Fromtheinterfaceconfigurationmode,usetheauthenticationcommandtoselectopen
system
authenticationandtheencry ptioncommandtoenabledataencryption.Usetheauthentication
commandtoenableWPAdynamickeysover802.1X.Setthebroadcastandmulticastkey
encryptionusingthecipher‐suitecommand.
Example
RoamAbout 4102#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 4102(config)#interface wire g
Enter Wireless configuration commands, one per line.
RoamAbout 4102(if-wireless g)#authentication wpa required
Data Encryption is set to Enabled.
WPA2 Clients mode is set to Disabled.
WPA Clients Mode is set to Required.
WPA Multicast Cipher is set to TKIP.
WPA Unicast Ciphers can accept TKIP.
WPA Authentication is set to 802.1X Required.
RoamAbout 4102(if-wireless g)#802.1X broadcast-key-refresh-rate 5
RoamAbout 4102(if-wireless g)#802.1X session-key-refresh-rate 5
RoamAbout 4102(if-wireless g)#802.1X session-timeout 300
RoamAbout 4102(if-wireless g)#