Enterasys RoamAbout RBT-4102 - Using the CLI to Configure WPA2 Pre-Shared Key Security

Security
4-92 Advanced Configuration
DTIM Interval : 5 beacons
Preamble Length : LONG
Maximum Association : 32 stations
Native VLAN ID : 1
VLAN State : DISABLED
----------------Security---------------------------------
Secure Access : ENABLED
Multicast cipher : AES
Unicast cipher : AES
PMKSA Lifetime : 720 minutes
WPA clients : REQUIRED
WPA Key Mgmt Mode : DYNAMIC
WPA PSK Key Type : HEX
Encryption : 64-BIT ENCRYPTION
Default Transmit Key : 1
Common Static Keys : Key 1: ***** Key 2: *****
Key 3: EMPTY Key 4: EMPTY
Pre-Authentication : Disabled
Authentication Type : WPA2-ONLY
----------------Authentication Parameters----------------
802.1X : REQUIRED
Broadcast Key Refresh Rate : 0 min
Session Key Refresh Rate : 0 min
802.1X Session Timeout Value : 60 min
=========================================================
RoamAbout 4102#
Using the CLI to Configure WPA2 Pre-Shared Key Security
Fromtheinterfacewirelessorinterfacewireless:VAPconfigurationmodes,usethe
authenticationcommandtoselectwpa2‐pskauthentication.Usethewpa‐pre‐shared‐key
passwordcommandtoenterapassword.
Examples
RoamAbout 4102#
RoamAbout 4102#configure
Enter configuration commands, one per line. End with CTRL/Z
RoamAbout 4102(config)#int wireless g
Enter Wireless configuration commands, one per line.
RoamAbout 4102(if-wireless g)#authentication wpa2-psk required
Data Encryption is set to Enabled.
WPA Clients Mode is set to Disabled.
WPA2 Clients Mode is set to Required.
WPA2 Multicast Cipher is set to AES-CCMP.
WPA2 Unicast Ciphers can accept AES-CCMP only.
WPA2 Authentication is set to Pre-Shared Key.
RoamAbout 4102(if-wireless g)#wpa-pre-shared-key pass 1234567890
RoamAbout 4102(if-wireless g)#exit
RoamAbout 4102#