Filter Control and VLANs
4-18 Advanced Configuration
• ManagementVLANIDspecifiesthemanagementVLANIDfortheaccesspoint.
ThemanagementVLANisformanagingtheaccesspoint.Forexample,theaccesspoint
allowstrafficthatistaggedwiththespecifiedVLANtomanagetheaccesspointviaremote
management,SSH,SNMP,Telnet,andsoforth.VLANmanagement
isenabledbydefault,and
cannotbedisabled.
• EthernetUntaggedVLANIDspecifiestheVLANIDtowhichtheAPmapsuntaggedpackets
enteringthroughtheAPʹsEtherne tport.Range:1to4094
•IAPP(InterAccessPointProtocol)enablestheprotocolsignalingrequiredforwirelessclients
toroambetweendifferent
802.11f‐compliantaccesspoints.SelectDisabletodisable802.11f
signaling.Default:Enable.
• IBSSRelayControl,inconjunctionwithradiointerfaceandVirtualAP(VAP)IBSSsettings,
controlswhetherclientsassociatedwithaninterfaceorVAPcanestablishwireless
communicationswithclientsassociatedwithotherinterfacesorVAPs.Default:AllVAP
mode
–InAllVA P Mode,clientsassociatedwithanyIBSSenabledradiointerfacesorVAPscan
establishwirelesscommunicationswitheachother.
–InPerVA P Mode,clientsassociatedwithaspecificIBSSenabledradiointerfaceorVAPcan
establishwirelesscommunicationswithotherclientsassociatedwiththesameinterfaceor
VAP.
Forexample,clientsassociatedwithVAP1canestablishwirelesscommunications
witheachotherbutnotwithclientsassociatedwithanIBSSenabledVAP2.
• WirelessAPManagementcontrolsmanagementaccesstotheRBT‐4102fromwirelessclients.
ManagementinterfacesincludetheWeb,Telnet,orSNMP.Default:Allow
– Disablepermitsmanagementaccess
fromwirelessclients.Thedefaultsetting.
– Enableblocksmanagementaccessfromwirelessclients.
• EthernetTypeFiltercontrolschecksontheEthernettypeofallincomingandoutgoingEthernet
packetsagainsttheprotocolfilteringtable.Default:Disable
– Disable:TheaccesspointdoesnotfilterEthernetprotocoltypes.
– Enable:Theaccess
pointfiltersEthernetprotocoltypesbasedontheconfigurationof
protocoltypesinthefiltertable.Ifaprotocolhasitsstatussetto“ON,”inthefiltertable,
theaccesspointfiltersthatprotocol.
– LocalManagementliststheEthernetprotocols.
– ISODesignatorspecifiestheISOdesignatorsforeachEthernet
protocollisted.
– Statusindicates,byradiobuttonselection,whethertheaccesspointfiltersthisEthernet
protocol.ONindicatesfilteringforthisEthernetprotocol.Offindicatesnofilteringforthis
Ethernetprotocol.
Note: You must set up the network switch port to support tagged VLAN packets from the access
point. The switch port must also be configured to accept the access point’s management VLAN ID
and native VLAN IDs.
Note: Ethernet protocol types not listed in the filtering table are always forwarded by the access
point.
To Next Page
Loading...
Need help?
General
