Enterasys RoamAbout RBT-4102 - Page 67

SNMP
RoamAbout RBT-4102 Wireless Access Point Configuration Guide 4-31
• Engine‐IDisusedforSNMPv3toidentifytheaccesspointinanetworkofmultipleaccess
points.
–EnteringtheEngine‐IDinvalidatesallengineIDsthathavebeenpreviouslyconfigured.
–IftheEngine‐IDisdeletedorchanged,allSNMPuserswillbecleared.Youwillneedto
reconfigureall
users.
• SNMPUsersallowsyouconfigurethesecurityrequirementofusersaccess.
localMacAddrAuthSuccess A client station successfully authenticated its MAC address with
the local database on the access point.
localMacAddrAuthFail A client station failed authentication with the local MAC address
database on the access point.
iappStationRoamedFrom A client station roamed from another access point (identified by
its IP address).
iappStationRoamedTo A client station roamed to another access point (identified by its
IP address).
iappContextDataSent A client station’s Context Data was sent to another access point
with which the station has associated.
dot11InterfaceGFail The 802.11g interface failed.
dot11WirelessSTPDetection A wireless STP packet has been detected.
Note: If you are going to use Group Lists, you must set up the Groups before adding the SNMP
users.
Table 4-3 SNMP Notifications (continued)