Entrematic Ditec E1A User Manual (English)

Other manuals for Entrematic Ditec E1A

Questions and Answers:

M
Mrs. Michelle LeeAug 9, 2025
Why Entrematic Control Panel automation opens but does not close?
- D
  David KelleyAug 9, 2025
  If your Entrematic Control Panel automation opens but doesn't close, consider these potential causes. The safety contacts may be open (SA led on), so check that they are closed correctly. Alternatively, the safety contacts may not be correctly connected, or the self-controlled safety edge SOFA1-SOFA2 may not be functioning correctly (SA led flashing); in this case, check connections to terminals 6-8 on the control panel and the connections to the safety edge. Also, check that the photocells are clean and operating correctly, as they may be activated (SA led on). Finally, the automatic closing may not be working because the TC trimmer is not set at the maximum.
A
Amy ThompsonAug 15, 2025
How to extend remote control range for Entrematic Control Panel?
- E
  ehansonAug 15, 2025
  If your Entrematic Control Panel's remote control has limited range or doesn't work when the automation is moving, it could be due to the radio transmission being impeded by metal structures and reinforced concrete walls. Try installing the antenna outside and substitute the transmitter batteries.
S
samuel60Aug 21, 2025
What to do if external safety devices aren't activating on Entrematic Control Panel?
- J
  James TuckerAug 21, 2025
  If the external safety devices are not activating on your Entrematic Control Panel, the issue may be incorrect connections between the photocells and the control panel. Connect NC safety devices together in series and remove any bridges on the control panel terminal board.
J
jrodriguezAug 27, 2025
Why is Entrematic Control Panel automation very weak?
- R
  Robin RamosAug 27, 2025
  If your Entrematic Control Panel automation is very weak and doesn't invert the movement, the motor’s condenser may have an incorrect capacity value. Replace the motor’s condenser.