5-157
Maintaining and Transporting the Printer | 157
Cleaning the Printer
To keep your printer working at its best, you should clean it several times a
year.
1. Make sure the printer is turned off and all the lights on the control panel
are off. Then unplug the power cord and disconnect the printer from
the computer.
2. Open the roll paper cover and remove the roll paper. Remove any sheet
media from the printer. Then use a soft brush to carefully clean away
any dust or dirt.
3. Open the lower cover and use a soft brush to carefully clean away any
dust or dirt inside the cover.
Some kinds of paper can cause paper dust to accumulate on the paper
feed roller. Clean the area shown below using canned air.
4. Remove the paper basket. Then clean away any dust or dirt around the
leg assembly using a soft brush.
5. If the outer case is dirty, clean it with a soft, clean cloth dampened with
mild detergent. Keep the ink cartridge compartment closed to prevent
water from getting inside.
6. If the area under the roll paper cover accidentally gets soiled with ink,
wipe it off with a damp cloth.
7. To wash the paper basket, remove the shafts, then machine wash with
mild detergent and air dry.
Caution
Be careful not to touch
the gears inside the
printer.
To avoid damaging the
components as well as
the case, never use
alcohol or thinners to
clean the printer.
Be careful not to get
water on the printer
mechanism or electronic
components.
Don’t use a hard or
abrasive brush.
Don’t spray the inside
the printer with
lubricants; unsuitable
oils can damage the
mechanism. Contact your
dealer or a qualified
servicer if you think the
printer needs lubrication.
Clean paper feed roller
To Next Page
Loading...
Need help?
General
