3-91
Printing with EPSON Drivers for Macintosh | 91
3. Select the Paper Size you want, based on the size of your image. If your
size is not listed, click
Customize. Then enter the size in inches or
centimeters. If you’re printing your image with borders, make your
custom page size slightly larger than the image size; if you’re printing
without borders, it should be slightly smaller (about 1/4 inch all
around).
4. If you’re using roll paper, you can set the following options:
• Auto Rotate
Saves paper if your document length is shorter than the printable
width of the paper roll. Your image is rotated automatically by
90 degrees and printed crosswise.
• Auto Cut
Choose this option if you want the paper to be cut automatically
after each page is printed (not available for thicker media types).
• Print Page Line
Prints trim lines on the right and bottom edges of your pages.
• Save Roll Paper
Saves paper by not feeding the blank portion of the last page of your
document. Available only when you’ve selected
Roll Paper
(Banner)
as the Paper Source.
5. Make the settings you want for
Orientation, Reduce or Enlarge,
Rotate, and Printable Area (if Paper Source is set to Sheet).
6. After making your settings, click
OK.
Printing Without Borders
You can print BorderFree
™
iamges on the following paper widths:
• 8 inches • 20 inches
• 10 inches • 24 inches
• 12 inches • 36 inches (Stylus Pro 9600 only)
• 14 inches • 44 inches (Stylus Pro 9600 only)
• 16 inches
Note
The Macintosh operating
system limits the custom
page length to 90.6 inches.
Note
For best print quality
along the upper edge of
your printout, EPSON
recommends using one
of the following papers:
• Premium Glossy
Photo Paper (250)
• Premium Semimatte
Photo Paper (250)
• Premium Luster
Photo Paper
Note that you can’t print
without borders when
using Photographic Dye
ink at 2880 dpi.
To Next Page
Loading...
Need help?
General
