EasyManuals Logo

Epson 9600 User Manual

Epson 9600
192 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #168 background imageLoading...
Page #168 background image
6-168
168 | Solving Problems
SET INK LEVER The ink lever was left in
the unlocked position.
Pull the lever down to lock the ink cartridges.
FRONT COVER
OPEN
Pause light on Front cover is open. Close the front cover.
TURN PRINTER
PWR OFF AND
ON
This message appears
after you clear a paper
jam.
Press the Power button to turn the printer off
and back on again.
UNABLE TO
PRINT
You tried to print while
an error condition was
present or the ink
compartment cover
was open.
After 3 seconds the message disappears.
Press the Pause button to exit SelecType
mode. If the message appears again, clear the
error before you print.
MAINTENANCE
TANK ALMOST
FULL
Maintenance
Tank light
flashing
The maintenance tank
is almost full.
Make sure you have a replacement
maintenance tank. See page 155.
CHANGE
MAINTENANCE
TANK
All lights
flashing
The maintenance tank
is full.
Replace the maintenance tank. See page 155
for instructions.
NO
MAINTENANCE
TANK
Maintenance
Tank light is
on
The maintenance tank
is not installed
correctly.
Make sure the maintenance tank is fully
inserted. See page 155 for instructions.
OPTION I/F
ERROR
Wrong interface card
installed.
Turn off the printer and remove the card. See
the documentation that came with the card.
SERVICE REQ. All lights
flashing
An error has occurred. Note the error number, then turn the printer off
and back on. If the message remains, contact
EPSON as described on page 11.
MAINTENANCE
REQ.
A printer part will need
to be replaced soon.
Note the error number and contact EPSON as
described on page 11. (If only the cutter blade
is worn out, you can replace it yourself. See
page 130 to check its status.)
COMMAND ERROR You’re using the wrong
printer driver.
Make sure you installed the correct driver for
your printer (see page 50).
Damaged data was
sent to the printer.
To clear the data, press the printer’s Power
button to turn the printer off. Wait for about a
minute, then turn the printer on again.
Error messages (continued)
Message Light Explanation Response

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson 9600 and is the answer not in the manual?

Epson 9600 Specifications

General IconGeneral
Maximum Resolution2880 x 1440 dpi
Max Resolution (BW)2880 x 1440 dpi
Max Resolution (Color)2880 x 1440 dpi
Media ThicknessUp to 1.5 mm
Ink TypeUltraChrome Ink
Maximum Print Width44 inches
Media HandlingRoll and Sheet
Ink Cartridge TypeIndividual Cartridges
ConnectivityUSB, Ethernet
Media SizeUp to 44 inches wide
Ink ColorsCyan, Magenta, Yellow, Black, Light Cyan, Light Magenta, Light Black
Media WidthUp to 44 inches
InterfaceUSB 2.0, Ethernet
Operating SystemsWindows, Mac OS
Print TechnologyInkjet

Related product manuals