1-49
Setting Up the Printer | 49
6. Insert the interface card as shown, then secure it with the two screws.
7. Connect one end of the appropriate
cable to the card. Then connect the
other end to your computer’s
FireWire port or Ethernet port or
hub.
8. If you’re using FireWire, attach the
ferrite core included with your
printer to the cable as shown.
If you’ve installed an Ethernet card, you can find more information on
setting up your printer in the Reference Guide included on the CD-ROM
that came with the printer. See “Setting Up Your Printer on a Network” in
the Printing with Windows or Printing with Macintosh section of the
Reference Guide.
attach
ferrite core
To Next Page
Loading...
