Epson G20 Series User Manual

Setup & Operation 1. Safety
14 G10 / G20 Rev.20
1.7 Warning Labels
The Manipulator has the following warning labels.
The warning labels are attached around the locations where specific dangers exist.
Be sure to comply with descriptions and warnings on the labels to operate and maintain
the Manipulator safely.
Do not tear, damage, or remove the warning labels. Use meticulous care when handling
those parts or units to which the following warning labels are attached as well as the
nearby areas.
Location Warning Label NOTE
A
Before loosening the base
mounting screws,
hold the
arm and secure it tightly with a
band to prevent hands or
fingers from being caught in
the Manipulator.
B
Do not enter the work space
when the Manipulators
operating. It is extremely
hazardous since the Arm may
collide and cause serious
safety problems,
C
Hazardous voltage exists
while the Manipulator is ON.
To avoid electric shock, do not
touch any internal electric
parts.
D
You can catch your hand or
fingers between the shaft
and
cover when bringing your
hand close to moving parts.
* Manipulators with bellows do
not have this label for no
danger of your hand or fingers
being caught.
E
Only authorized personnel
should perform sling work and
operate a crane. When
these
operations are
performed by unauthorized
personnel, it is extremely
hazardous and may result in
serious bodily injury and/or
severe equipment damage to
the robot system.

Epson G20 Series Specifications

General

Brand	Epson
Model	G20 Series
Category	Robotics
Language	English