Epson G20 Series User Manual

Setup & Operation 3. Environments and Installation
G10 / G20 Rev.20 43
Special Environmental Conditions
The protective seals are attached on the Protected-model Manipulator to prevent dust,
water, etc. from the outside. Follow the precautions in use environment described below:
The surface of the Manipulator has general oil resistance. However, if your requirements
specify that the Manipulator must withstand certain kinds of oil, please consult your
distributor.
Rapid change in temperature and humidity can cause condensation inside the Manipulator.
If your requirements specify that the Manipulator handles food, please consult your
distributor to check whether the Manipulator will damage the food or not.
The Manipulator cannot be used in corrosive environments where acid or alkaline is used.
In a salty environment where the rust is likely to gather, the Manipulator is susceptible to
rust.
The controller used with the Protected-model Manipulator does not have protection
features for dusty, wet, or oily environment. The controller must be placed in an
environment that meets the specified conditions.
WARNING
■
Use an e
arth leakage breaker on the AC power cable of the Controller to avoid
electric shock and circuit breakdown caused by
short circuit.
Prepare the earth leakage
breaker that pertains the Controller you are using.
For details, refer to the
Controller manual.
CAUTION
■
When cleaning the Manipulator, do not rub it strongly with alcohol or
benzene.
It may lose luster on the coated face.

Epson G20 Series Specifications

General

Brand	Epson
Model	G20 Series
Category	Robotics
Language	English