Epson RC90 User Manual

Maintenance 9. Troubleshooting
No. Message Remedy Note 1 Note 2
1032
Cannot execute while the maximum
number of tasks are executing.
Stop the task and then execute.
1033
Cannot execute during asynchronous
motion command.
Execute after the motion ends.
1034
Asynchronous command stopped
during operation.
The asynchronous command already
stopped when the controller received a
stop command.
1035
Cannot execute when Remote I/O
enabled except from the remote
device.
1036
Cannot execute when OP enabled
except from the OP.
1037
Cannot execute when Remote Ethernet
enabled except from the remote
Ethernet device.
-
1039 Execution is prohibited. -
1041
Cannot execute during Emergency
Stop status.
Cancel the Emergency Stop status.
1042
Cannot execute while the safeguard is
open.
Close the safeguard.
1043
Cannot execute during error condition.
Cancel the error condition.
1044
Cannot execute when the remote pause
input is ON.
Change the remote pause input to OFF.
1045
Input waiting
condition is the only
available condition to input.
The controller received an input while it
was not in the Input waiting condition.
1046
Cannot execute during file transfer.
Execute after the file transmission.
1047
Cannot cancel the command executed
from other devices.
Cancel the motion command from the
device the command was issued from.
1048
Cannot execute after low voltage was
detected.
1049 Other devices are in program mode.
1050
Password is too long.
1051
Export Controller Status failed.
1052
Export Controller Status busy.
1053
Cannot execute in TEST mode.
1054
Cannot execute in TEST mode except
from TP.
1055
Cannot execute the Background Task.
1100 File failure. Cannot access the file.
1102
File failure. Read and write failure of
the registry
1103
File is not found.
Check whether the file exists.
1104
Project file was not found.
Rebuild the project.
1105
Object file was not found.
Rebuild the project.
1106
Point files were not found.
Rebuild the project.
1107
The program is using a feature that is
not supported by the current controller
firmware version.
1108
One or more source files are updated.
Please build the project.
Rebuild the project.
1109 Not enough storage capacity. Increase free space of the USB memory.
1110
File is not found.
1111
Conveyor file was not found.
RC90 (EPSON RC+ 7.0) Rev.4
120

Epson RC90 Specifications

General

Brand	Epson
Model	RC90
Category	Controller
Language	English