Epson RC90 - Page 167

Maintenance 9. Troubleshooting
No.
Message
Remedy
Note 1
Note 2
3231 Above/Below was not specified.
3232 Righty/Lefty was not specified.
3233 NoFlip/Flip was specified.
3234 Port number was not specified.
3235 String type variable was not specified.
3236
RS-
232C port number was not
specified.
3237
Network communication port number
was not specified.
3238
Communication speed was not
specified.
3239 Data bit number was not specified.
3240 Stop bit number was not specified.
3241 Parity was not specified.
3242 Terminator was not specified.
3243 Hardware flow was not specified.
3244 Software flow was not specified.
3245 None was not specified.
3246
Parameter ' O ' or ' C ' was not
specified.
3247 NumAxes parameter was not specified.
3248 J4Flag value (0-1) was not specified.
3249 J6Flag value (0-127) was not specified.
3250 Array variable was not specified.
3251
String Array variable was not
specified.
3252
Device ID was not specified.
3253
I/O type was not specified.
3254
I/O bit width was not specified.
3255 ByRef was not specified.
Although the ByRef is specified in the
function declaration, no ByRef is
specified for calling.
3256
Variable type was not specified.
3257
Condition expression does not evaluate
to Boolean value.
3258
RS232C port number was not
specified.
3259
Network communication port number
was not specified.
3260
Language ID was not specified.
3261
Expected '.'.
3262
Vision Sequence Name was not
specified.
3263
Vision Sequence Name or Calibration
Name was not specified.
3264
Vision Property Name or Result Name
was not specified.
3265
Vision Property Name, Result Name or
Object Name was not specified.
3266
Vision Calibration Property Name was
not specified.
RC90 (EPSON RC+ 7.0) Rev.4
151