Epson Stylus Color 1520 User Manual

Printing on Special Media
3-25
7. Clip the banner paper cutting guide onto the output tray
posts.
8. Slide the left banner paper holder all the way to the left and
slide the right banner paper holder approximately 1/8-inch
(3 mm) from the far right edge.
9. Position the roll paper so it feeds into the printer as shown
below, with the printable side face up. Then place it onto
the right banner paper holder and slide the left holder over
to support the roll. Align the roll paper’s edges with the
edge guides on the holders.
Caution:
Adjust the banner paper
holders so they fit the roll
paper snugly, but not so
tightly that the roll can’t
rotate. If they’re too tight,
the paper won’t feed into
the printer.
set to about 1/8-inch (3 mm)
from the far right position
media.fm5 Page 25 Friday, May 9, 1997 1:50 PM

Epson Stylus Color 1520 Specifications

General

Color	Yes
Maximum resolution	600 x 1200 DPI
Print speed (black, normal quality, A4/US Letter)	- ppm
Maximum input capacity	100 sheets
Envelopes sizes	10, C5, DL
Standard media sizes	4\
Paper tray media types	Envelopes, Labels, Plain paper
Non-ISO print media sizes	Legal
ISO A-series sizes (A0...A9)	A4
ISO B-series sizes (B0...B9)	B5
Power requirements	120V AC, 50/60 Hz
Printing noise level	45 dB
Maximum operating temperature range (T-T)	-20 - 60 °C
Market positioning	Home & office