EPSON Stylus COLOR 670 Revision A
Adjustment Using the Adjustment Program 103
5.3 Using the Adjustment Program
In this printer, it is necessary to set the adjusting information for each
printer mechanism in order to maintain consistent printing function and
quality, eliminating differences of each printer mechanism’s
characteristics. Therefore, in case that the combination of the printer
mechanism and main board changes or the print head is replaced during
the repair service, you must set and save the correct information to the
MAIN board, using the exclusive adjustment program.
5.3.1 Adjustment Program Installation Procedure
This adjustment program is in the 3.5 2HD FD. The first FD is the installer
disk. When you execute Setup.exe, the installation of the program will be
started under Windows 95/98. After installation is completed, the EPSON
Stylus COLOR 670 icon will be automatically made in the program menu.
Go “Start” -> “Program” and click the icon to start this program.
5.3.2 Adjustment Program
This adjustment program is exclusive for Windows: the OS that allows
operation of this program is Windows 95/98. The following shows
programs included in this program.
CHECK
POINT
n This adjustment program operates only under Windows
95/98: This program does not operate under DOS or
Windows 3.X.
n This adjustment program automatically installl the
appropriate program according to your OS.
n Perform this adjustment program using parallel I/F port.
To Next Page
Loading...
Need help?
General