Epson Stylus Color 670 Service Manual

EPSON Stylus COLOR 670 Revision A
Adjustment Using the Adjustment Program 111
5. Look very closely at the black/magenta lines in the printed pattern and
move the adjustment lever to center the magenta lines between the black
lines. The figure below shows how to move the lever to correct a
misaligned pattern.
If the series of magenta lines are below the center of the series of black
lines, shift the adjustment lever position toward the front of the printer. If
the series of magenta lines are above the center between the series of
black lines, shift the adjustment lever position toward the rear of the
printer.
Figure 5-12. Head Angular Adjustment Lever - Adjusting Method
6. Select “Print the head angular adjustment pattern” and perform the test
print. If more adjustment is necessary, repeat steps 2 to 5; otherwise
proceed to step 7.
7. After finishing the adjustment, tighten the head screw while holding the
unit. (If necessary, select “Move the carriage to the adjustment position”,
click OK, and then tighten the screw.)
8. Select “Return the carriage to the home position” and click OK. When the
carriage stops moving, the adjustment is finished.
Figure 5-13. Move the carriage to the home position
To move this down
Move the lever
to the rear
Correct condition = vertical
spacing is even
To move this up
Move the lever
to the front
Adjustment lever

Epson Stylus Color 670 Specifications

General

Brand	Epson
Model	Stylus Color 670
Category	Printer
Language	English