21
2. Remove the FFC cable from the connector and hook.
Figure 4-6. Panel Unit Removal 2/2
3. Remove nine screws then remove the panel board.
Figure 4-7.
rth
C H E C K
P O I N T
You may find it easy to remove the panel unit if you stand on the front
of the printer and use both hands to pull (squeeze) the panel towards
then lift up. (Refer the above figures and arrow directions. This way
you remove first the rear-side hook, then you can easily remove it.
Connector
Hook
FFC Cable
When replacing the panel board and FFC, make sure you push the
FFC cable slack inside and towards the rear of the printer to avoid
interfering with carriage movement.
When installing the panel unit, place the grounding plate under the R-
side cover then push and lock it to the R side cover.
To Next Page
Loading...
