Epson StylusPro 10000 - Removing the PF Encoder

EPSON Stylus Pro 10000/10000CF Revision A
Disassembly & assembly Disassembly Flow
1
66
4.2.3.10 Removing the PF Encoder
1. Disconnect the PF Encoder cable connector.
Figure 4-120.
2. Loosen the set screw (2mm), and remove the bearing stopper.
Figure 4-121.
3. Remove four serews fixing the PF base.
Figure 4-122.
4. Remove the Grid spacer and the Grid end.
Figure 4-123.
Cable connector
Bearing stopper
PF base
Screw
Grid end
Grid spacer