lecType Settings 49
1.6.6 Gap Adjustment
Selecting this mode allows the user to adjust the following.
<Setup>
1. Set the paper in place.
2. Select the gap adjustment menu from the panel.
3. Set to ’STD’ when using EPSON paper (0.2mm or 1.2mm thick). For other paper, set
thickness in units of 0.1mm.
4. Select the adjustment pattern to be printed (all or individual), and print.
5. Check the printed adjustment patterns and enter the number of the pattern with the least
displacement for each adjustment item.
6. Repeat (4)~(5) until adjustment of all items is complete.
Figure 1-11. Gap Ajustment print pattern
Figure 1-12. Gap Ajustment print pattern
Table 1-34.
Items
Paper thickness (in 0.1mm units)
Bi-d adjustment 1 (240cps, VSD1, Small)
Bi-d adjustment 2 (300cps, VSD2, Large)
To Next Page
Loading...
