Epson StylusPro 10000 - Removing the PF Motor ASSY

EPSON Stylus Pro 10000/10000CF Revision A
Disassembly & assembly Disassembly Flow
1
64
6. Remove the four screws (CP(W) M4x10) securing the CR motor and remove the CR
motor with roller.
Figure 4-115. CR Motor Removal
4.2.3.9 Removing the PF Motor ASSY
1. Remove the L Side Cover as described in “L Side Cover Removal 124.
2. Remove the Rear Cover as described in “Rear Cover Removal 126.
3. Disconnect the PF Motor ASSY cable connector.
Figure 4-116.
4. Loosen the four (CP(W) M4x10) screws securing the PF motor bracket.
A D J U S T M E N T
R E Q U I R E D
When removing the CR Motor, the following adjustment procedures
are required.
n “CR Timing Belt Tension Adjustment”
C A U T I O N
Pay attention so as not to scar the steel belt.
Screw
Roller
CR motor
PF Motor cable connector