Epson StylusPro 10000 - Removing Paper Guide U

EPSON Stylus Pro 10000/10000CF Revision A
Disassembly & assembly Disassembly Flow
1
31
7. Remove the Hinge unit L with Hinge.
8. While supporting the Front cover, lower the left side and slide to left, then remove the
Front cover.
4.2.1.11 Removing Paper Guide U
1. Remove the R Side Cover as described in paragraph 4.2.1.3.
2. Remove the L Side Cover as described in paragraph 4.2.1.4.
3. Remove the H Top Cover as described in paragraph 4.2.1.6.
4. Remove the Rear Cover as described in paragraph 4.2.1.7.
5. Remove the six screws (CS:M4x8) securing Paper Guide U.
Figure 4-37.
6. Remove the FFC from rear side.
C A U T I O N
When removing / installing, hold the “Front Cover” with your hand
and do not drop it.
n When installing the “Front Cover”, make sure the shape of cover
springs. (Shape are different with right and left.)
n Confirm the movement of the cover and operation of the cover-
open sensor (mounted inside of right hinge unit) .
n When installing, make sure the shape (D cut) of shaft on the both
hinge unit then align the shaft hole on the Front Cover.
Figure 4-36.
Hole
S
h
a
f
t
Front Cover
Hinge unit
(Right side view)
Paper Guide U
(Right-Rear side view)
(Left-Rear side view)
Screw
Screw