37
o
It prints it in the order of Black/Cyan/Magenta/Yellow/Light Magenta/Light Cyan
from the left.
Figure 5-54.
6.Vertical nozzle lineup confirmation.
o It prints in the order of Black/Cyan/Magenta/Yellow/Light Magenta/Light Cyan
from the left.
Figure 5-55.
5.3.4.5 Offset Adjustment
Perform the dot missing detection and adjust the offset value automatically.
1. Move to Adjustment mode in the self-diagnostics.
2. Select Paper Source or Select Type switch to the Offset Adjustment, and then push
Enter key to enter offset adjustment.
3. The printer performed offset adjustment automatically and display the result as
following.
Figure 5-56.
The display digit showing
in the order of
AGC threshold value/DAC max/and DAC
mini.
from the left.
C A U T I O N
n The offset adjustment will not be performed when Auto nozzle
check setting is OFF in the maintenance mode.
Wait a moment
Res:2640 2640 2384
AGC threshold
DAC max. DAC mini.
To Next Page
Loading...
