41
4.2.2.6 P/S Fan Removal
1. Remove the Rear Cover as described in paragraph 4.2.1.7.
2. Remove the connector from CN1 on the C362MAIN board, and unlock from the cable
clump.
Figure 4-57.
3. Remove one screw fixing the earth plate connected to CN42 on the C362MAIN board,
and disconnect fan cable connector.
Figure 4-58.
4. Remove one screw securing the P/S Fan holder, then remove it.
Figure 4-59.
5. Remove two screws securing the P/S Fan on the P/S Fan Holder, and remove it.
Figure 4-60.
Cable Connector
Cable Clump
Connector
Auto take-up roller connector
Screw
Screw
P/S Fan Holder
Fan screw
P/S Fan Holder
To Next Page
Loading...
