pecifications 26
1.2.10.2 Vibration & Shock
See the following table.
Notes:
* Make sure the printhead is capped during transportation and storage. To cap the printhead,
turn the power on (with ink cartridges installed) and turn the power off when the printheads
are capped.
* To thaw frozen ink in the printer or cartridge, leave the printer out at a temperature of 25°C
(77°F) for approximately three hours.
1.2.11 Controller
CPU: Hitachi SH7709A, 120MHz
Code ROM: 2MB
Font ROM: None
RAM: 128MB (fixed)
Interfaces: IEEE1284 interface
USB1.1
Type B interface (2 expansion ports)
Operating System: Hitachi HI7700 (µITRON 3.0 compatible)
Table 1-10. Vibration and Shock
Condition
Vibration
Resistance
Shock
Resistance
Notes
Operating
0.15G
10~55Hz
1G
maximum 1ms
X/Y/Z directions
Storage
0.5G
10~55Hz
2G
maximum 2ms
To Next Page
Loading...
