Epson StylusPro 10000 - HJFK; Dummy Board Removal

EPSON Stylus Pro 10000/10000CF Revision A
Disassembly & assembly Disassembly Flow
1
34
3. Disconnect the P/S self-containing fan connector connected to CN39 on the C362DRV
board.
Figure 4-42.
4. Remove the four white screws (CPS:M3x8) securing the Power Board, and then
remove the Power Board.
Figure 4-43.
4.2.2.2 HJFK / Dummy Board Removal
(Any of the HJFK board or the Dummy board of the option are fixed.)
1. Remove the rear cover as described in “Rear Cover Removal” (Paragraph 4.2.1.7.)
2. Pull off the “Option block” to the upward.
Figure 4-44.
P/S Self-containing
Fan
Disconnect cable connector
Screw
Screw
Screw
Screw
Option block
HJFK / Dummy
board