Epson StylusPro 10000 - 4.2.3 Disassemble Printer Mechanism

EPSON Stylus Pro 10000/10000CF Revision A
Disassembly & assembly Disassembly Flow
1
42
4.2.3 Printer Mechanism Disassembly
This section describes the Printer Mechanism components and the procedure for
Disassembly.
When replacing the fan, make sure the setting direction.
Figure 4-61.
Label
C A U T I O N
n Do not remove or loosen the screws that secure the CR guide rail,
also do not remove the carriage. These parts are adjusted to 1/
100th of a mm at the factory.
n Do not attempt any kind of service or adjustment to the frame or
parts attached directly to the frame. See the Parts List in
Chapter 7 for a list of parts that you can service/replace. Other
parts can only be assembled and adjusted at the factory.
Figure 4-62.
CR Guide rail
Hexagon Screw