26
5. Opening I/C holder cover by pushing the central upper part (the cover latch location) of
it,then remove I/C holder cover with the hinge of the right and left.
6. Removing the E ring, then I/C holder cover and slowing-down gear are separated.
Figure 4-21.
4.2.1.7 Rear Cover Removal
1. From the rear, remove four white screws (CPS:M3x12) securing the optional interface
cover, and remove the optional interface cover.
Figure 4-23.
2. Removing (CBS: 1 M3x6) the screw fixing HJFK (Dummy) board, then extract HJFK
(Dummy) board.
Figure 4-24.
C H E C K
P O I N T
When installing the “I/C Holder Cover”, make sure the position of
cover latch and cover interlock are placed correctly with frame.
Figure 4-22.
I/C Holder Cover
Ering
Slow-down gear
Switch lever
Screw
Screw
Optional interface cover
HJFK board / Dummy board
Screw
HJFK board / Dummy board
To Next Page
Loading...
