Epson StylusPro 10000 - H Top Cover Removal

EPSON Stylus Pro 10000/10000CF Revision A
Disassembly & assembly Disassembly Flow
1
23
4.2.1.3 H Top Cover Removal
1. Open Front cover and Roll paper cover
2. Remove top side four screws (CS : M4x8), then remove front side two screws (CS :
M4x8).
Figure 4-12.
3. Remove the H top cover by pulling up and toward the front.
Top side
four screws
Fronttwo
screws
(Top View)
(Front View) Screw
C A U T I O N
Make sure the left and right grounding plates do not get bent during
the disassembly / assembly process.
Figure 4-13.
grounding plates