69
5.3.8.4 Cutter
Perform the cutter reliability test.
Perform the cut designated number at designated parameter.
When the reliability number is [-1], reliability is repeated until key is input.
When the reliability number is [-1], the biggest count number is 99,999,999 times (within 8
column), and the count become 0 in the case that this is exceeded.
Following figure showing the cutter reliability test menu sequence.
Enter
Soft Landing 1 : 80%
Soft Landing 2 : 60%
Soft Landing 3 : 40%
Soft Landing 4 : 60%
Soft Landing 5 : 40%
Paper Pre. 100%
Pressure 60%
1
Adjustable with "Paper Feed +/-" key
atunitof1%
Adjustable with "Paper Feed +/-" key
atunitof1%
Adjustable with "Paper Feed +/-" key
atunitof1%
Adjustable with "Paper Feed +/-" key
atunitof1%
Adjustable with "Paper Feed +/-" key
atunitof1%
Adjustable with "Paper Feed +/-" key
atunitof1%
Adjustable with "Paper Feed +/-" key
atunitof1%
Enter
Enter
Enter
Enter
Enter
Enter
To Next Page
Loading...
