36
4. Slide to the left and unplug the CN1 connection to the main board.
Figure 4-48.
5. Unlock and push the four hooks from solder side.
Figure 4-49.
6. Unlock the four fooks on the connector CN4 and CN5 then remove two guides.
Figure 4-50.
C362DRV board
C362MAIN board
CN1
Hook
Hook
C A U T I O N
When replacing the “Interface Board”, make sure followings.
n UsesametypeofROMontheIC2.
n Do not exchange the mounting position of option board.
(Option board will be connect to the CN4/CN5 card slot.)
Figure 4-51.
Hook
Hook
CN5
CN4
Guide
IC2 (ROM)
CN5
CN4
To Next Page
Loading...
