45
5. Remove the Waste Ink Box by sliding it forward so the hooks on both sides release and
then pull up.
Figure 4-67. Waste Ink Box
6. Remove three screws on the ink tube clamp and remove it.
Figure 4-68. Disassembly of the Waste Ink Box
7. Remove the old Waste Ink Unit and dispose of them properly.
8. Insert new Waste Ink Unit, and re-install the Waste Ink Box in the printer.
Ink tube clamp
Screw
Waste Ink Unit
C H E C K
P O I N T
When replacing the Waste Ink Unit, prepare a vinyl bag beforehand
for disposal of the Pads.
A D J U S T M E N T
R E Q U I R E D
When replacing the Waste Ink Unit, the following adjustment
procedures are required. See “Maintenance Mode 2” on page 50.
n INIT. WASTE INK
n INIT. CLEANING
To reassemble the waste ink box and related parts, follow the above
steps in reverse order and make sure you keep the following in mind:
n The waste ink tubes should be inserted into the ink tube clamp.
n Make sure the tubes are not twisted or pinched.
Figure 4-69.
(Front side view)
Connect to the Creaning unit.
Connect to the flushing box.
To Next Page
Loading...
