Chapter 3 Handling
147
3
The label size and
printable area do not
match
It is product specifica-
tions
On the [General] tab, if you select
[User Defined...] in Media Layout
but do not select [Borderless Print-
ing], the area minus the 1.5 mm
margins around the label becomes
the printable area.
Enable [Borderless Printing] if you
want to use the whole label size as
the printable area.
When [Borderless Printing] is
enabled, images may be printed
on the backing paper; therefore,
remove the 1.5 mm margin on all
edges from the print data.
-
I want to perform bor-
derless printing
-
To perform borderless printing, use
the label that is cut in half and still
has edge cutoffs. Specify a print-
able area that is larger than the
actual label size and print.
See "Setting the label size and
paper layout for borderless printing"
on page 172 on page.
-
Print position and cut
position are misaligned
The print position may
be misaligned
depending on the
paper you are using.
Adjust the position.
On the printer driver’s [Printer Utili-
ties] tab, click [Printer Setting Utility].
When the PrinterSetting screen is
displayed, click [Printer Adjustment]
and perform [Paper Feed Adjust-
ment].
You can perform [Cut Position
Adjustment] [Print Start Position
Adjustment (Vertical Direction)],
and [Print Start Position Adjustment
(Horizontal Direction)].
See "Paper Feed Adjustment" on
page 129.
-
Trouble Description Recovery method
Image/
Illustra-
tion
To Next Page
Loading...
