Disassembly and Assembly 2-14 Rev. A
Confidential
9. Insert the crank shaft holder from the left and right outer sides attach with one E-ring.
Figure 2-13
10. Press the lever drive shaft gear into the drive gear assembly lever.
11. Install the sub slip feed assembly roller into the main sub assembly set frame. Align the D-
cut side of the sub slip feed assembly roller with the left side of the frame and the the
opposite side of the shaft with the U groove.
12. Press in the slip drive gear onto the sub slip feed assembly roller. Press in starting from the
slip drive gear whose diameter is larger. (see the illustration on the next page.)
13. Snap fit the lever drive motor detector plate to the lever drive motor gear.
619
Form stopper spring
684
E-ring(1.5)
694 Crank shaft holder
691 screw(C.B.S-tite F,3X6)
688 E-ring(5)
617
Form stopper
659
Lever drive motor assembly
705
Lead wire (type A)
641
Sub slip feed lever spring
694
Crank shaft
holder
618
Form stopper shaft
691 screw(C.B.S-tite F,3X6)
729
screw(C.B.,2.6X4)
690
screw(C.C.S-tite,2.5X5)
644
Sub slip feed roller holder
706
Lead wire
(type B)
636 Sub slip feed lever shaft
665
Lever drive shaft
assembly
To Next Page
Loading...
Need help?
General