Rev. A Adjusting 3-11
TM-H6000/H6000P Service Manual
Confidential
Threshold Value Setting for Detectors
Perform this setting when you have performed any one of the following.
1. Remove slip paper if it is set.
Note:
You cannot make accurate settings if there is any slip paper remaining. There is no problem if roll
paper is present.
2. Connect the power supply to the printer.
3. Open the roll paper cover.
4. Turn on the power switch to the printer while pressing the FEED button and the RELEASE
button at the same time.
5. Press the RELEASE button 7 times.
6. Close the roll paper cover.
7. The printer will automatically set the detector. The main circuit board will store the setting
values.
Items Requiring Setting
❏
When you replaced the Slip T. O. F. detector assembly.
❏
When you replaced the Slip B. O. F. detector assembly.
❏
When you replaced the paper ejection detector assembly.
❏
When you replaced or repaired the main circuit board assembly (for TM-
H6000/H6000P).
To Next Page
Loading...
Need help?
General