Introduction to this Guide
1553-CNH 160 0787 Uen PA2 2005-09-23
3
• The CLI commands have been revised and new commands have been
added in order to support the new topologies (embedded nodes, and
daisy chaining).
• Support of reverting an ECN to an ESN310 and back again.
1.2.4 Version E
The following has been changed:
• Support of ELN220 in an EAN is described
• Support of unaware VLAN in ECN from CLI is described
• Support of ECN auto completion on parameter added
• Change of password through the CLI added
• Correction of the CLI command link-configuration
• Minor corrections of illustrations
1.2.5 Version D
The following has been changed:
• Correction to the CLI command: link-configuration
• Minor textual corrections to sections 2, and 3.
• The section describing installation and upgrading of software has been
revised and moved.
• The sections have been slightly rearranged.
1.2.6 Version C
The following has been changed:
• The ECN has been supplied with dual power input ports
• The rear of the ECN has been supplied with two 20A fuses, one for
each power input
• The ECN has been supplied with an uplink 100 Base-FX option
To Next Page
Loading...
