Ericsson ECN320 - Prompt

Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
141
Command level: ecn330 (config system)#.
Syntax
pem-management port {25|26|27|disable}
Arguments:
• port 25/26/27/disable
Default Settings
Disabled
Command Usage
This command is used to set the port for PEM management or to disable
PEM management. If PEM management is enabled on a port, that port is
connected to the public management VLAN for untagged traffic. By default
the ECN does not allow untagged traffic through the uplink ports. VLAN 246
is configured as external management VLAN, so VLAN 246 is configured
as tagged VLAN on all uplink ports.
This means that incoming and outgoing traffic tagged with VLAN ID 246
can pass these ports. If pem-management is enabled on one uplink port of
the ECN, VLAN 246 is configured as untagged on this port. This means
that untagged traffic running through that port is internally tagged with
VLAN 246. A host connected to this port sending and receiving untagged
traffic (like a normal PC) would appear like being connected to VLAN 246.
This functionality has been implemented for allowing the operators to con-
nect a laptop to a port of the ECN and reach the PEM management VLAN.
Example
ecn330(config system)# pem-management port disable
11.6.10.11 prompt
The command prompt can be changed using this command.
Command level: ecn330(config system)#.
Syntax
prompt [<string>|none]