Command Line Interface
1553-CNH 160 0787 Uen PA2 2005-09-23
99
spanning-tree
Configure the spanning tree 108
unmanaged-switch
Add or remove an unmanaged switch 115
ip
Configurations related to IP.
switch-extension
Add or remove ELN220, ESN310,
ECN320-ESN310-switch or ECN330-
switch
116
auto-rediscover
Configure periodic rediscovery 120
11.6.3.1 inventory
Use this command to remove a node that is unreachable from the inventory
table of the ECN.
Command level: ecn330(config)#.
Syntax
ecn inventory remove node <node>
Arguments:
• node <node> - Specify the number of the node in the format
a.b
Default Settings
None
Command Usage
This command is used for removing nodes from the inventory table, for ex-
ample a node that is no longer in use or a node that is replaced with a dif-
ferent type of node (for example EDN312 instead of EDN110). Nodes that
are the same type can just be replaced physically without any further ac-
tion. A line configuration associated to the removed node is lost.
Example
ecn330(config)# ecn inventory remove node 1.0
To Next Page
Loading...
