Command Line Interface
76 1553-CNH 160 0787 Uen PA2 2005-09-23
Default Settings
-
Command Usage
When logging on to the embedded switch or daisy chained switch the
prompt change from ecn330# to Vty-0#. Type exit to go back to
normal CLI from the ECN.
Examples
ecn330#rcli 0.1
11.5.5 restart
Use this command to restart nodes.
Command level: ecn330#.
Syntax
restart {ecn330|switching-unit|enc}
restart reset-on-lan node <node>
restart node {<node>|all}
Arguments:
• ecn330 – restarts both ENC and the switching unit
• switching-unit – restarts the switching unit
• enc – restarts the Ethernet Node Controller
• reset-on-lan node <node> - Specify the node no. to restart
in the format a.b.
• node <node>/all – Specify the node no. to restart in the format
a.b or restart all.
Default Setting
None
To Next Page
Loading...
