Command Line Interface
74 1553-CNH 160 0787 Uen PA2 2005-09-23
Example
ecn330(config system)# end
11.5.2 exit
Using the command exit will bring the command level to the previous
level.
Command Level: Any.
Syntax
exit
Default Setting
None
Command Usage
This command is used to bring the command level to the previous level.
The command can be used at all command levels. At the root level the CLI
is terminated. The command end will give the root level (see section
11.5.1
on page
73).
Example
ecn330(config system)# exit
11.5.3 ping
Use this command to test the IP connection to another device.
Command level: ecn330#.
Syntax
ping <IP_address>
Arguments:
• ping <IP_address> - Insert the IP address of the node in the
format xxx.xxx.xxx.xxx.
To Next Page
Loading...
