Ericsson ECN320 - Fallback State CLI Commands

Command Line Interface
156 1553-CNH 160 0787 Uen PA2 2005-09-23
Default Setting
None.
Command Usage
This command is used to display general system configuration data.
Example
ecn330# show system calendar
11.9 Fallback State CLI Commands
Table 20 lists the CLI commands in the fallback state.
11.9.1 Commands
Table 20 Fallback CLI Commands Overview
Keyword Argument Action
calendar*
Sets local date and time in the NTP server
exit
Exits the CLI session
external
Sets VLAN, IP Address and Subnet mask for the external
interface
Internal
Sets VLAN, IP Address and Subnet mask for the internal in-
terface
untagged
Sets VLAN, IP Address and Subnet mask for the untagged
interface
interface*
default-
gateway
Sets the IP Address of the default gateway in the ECN
restart enc
Restarts the ENC
update software
Installs SW in the ENC
Status
Shows the status of the ECN
show
Log
Shows the content of the log
clear* network
Deletes all interfaces configuration
inventory
Deletes the inventory table