Command Line Interface
130 1553-CNH 160 0787 Uen PA2 2005-09-23
11.6.9 save-configuration
Use this command to save the running configuration.
Command level: ecn330(config)#.
Syntax
save-configuration
Default Setting
None
Command Usage
This command is used to save the running configuration file in the flash
memory of the ECN. The command restart will load the last saved con-
figuration on the node.
Example
ecn330(config)# save-configuration
11.6.10 system
Table 18 system commands
Command Description Page
aaa
Enable or disable the use of RADIUS
server
131
backup-configuration
Used to store configuration information 132
calendar
Set time and date 132
cli-autologout
Set an interval after which the CLI auto-
logs out
133
install
Install embedded nodes SW in the em-
bedded nodes
134
interface
Configure the IP and VLAN properties of
the ECN interfaces
135
local-management
Control untagged management traffic 137
To Next Page
Loading...
