Command Line Interface
126 1553-CNH 160 0787 Uen PA2 2005-09-23
line-type
Set the line type 127
11.6.6.1 line
Use this command to configure the EXN104 lines.
Command level: ecn330(config)#.
Syntax
exn <node> line <line> {state {enable|disable}|sync
{master|slave}|test {disable|line-loop}}
Arguments:
• exn <node> - EXN104 node no. in the format a.b
• line <line> – The line no. in the range 1 to 4
• state enable/disable - Enable or disable the operational
state of the EXN104 line.
• sync master/slave - Set the synchronisation mode of the line
to master or slave
• test disable/line-loop - Disable the line-loop test mode or
enable the line-loop test mode.
Default Setting
None.
Command Usage
The command is used to configure the EXN104.
Example
ecn330(config)# exn 3.100 line 3 state enable
ecn330(config)# exn 3.100 line 3 sync master
ecn330(config)# exn 3.100 line 3 test line-loop
To Next Page
Loading...
