Command Line Interface
98 1553-CNH 160 0787 Uen PA2 2005-09-23
− 16: ITU-T ADSL2+, G.992.5 Annex M
Default Setting
Autodetect
Command Usage
There are different ADSL standards that can be used in an ADSL connec-
tion. The use of the transmission mode depends on the equipment and in-
stallation in the customer premises. The IP DSLAM supports multi-annex
on a per line basis, except for ADSL over ISDN. If ADSL over ISDN is used,
all lines of the same IP DSLAM are set to ADSL over ISDN.
Choosing AUTO ADSL1 or AUTO ADSL2 will let the IPDSLAM to decide
which access method is appropriate or more exact CPE access method.
ADSL1 includes bunch of ADSL CPE access methods. ADSL2 includes
bunch of ADSL2 and ADSL2+ CPE access methods
Note: It is recommended to select the AUTODETECT. The
AUTODETECT negotiates with the CPE modem and selects auto-
matically the transmission mode.
Example
ecn330(config)# dslport 1.0.1 transmission-mode 2
11.6.3 ecn
Table 10 ecn commands
Command Description Page
inventory
Remove unreachable nodes from the in-
ventory table
99
link-aggregation
Configure a trunk with 2 ports that can be
used as a single link
100
port
Configure spanning tree parameters on a
single interface
101
to
106
redundancy
Ensure that the End-user traffic will con-
tinue when the ECN is down
101
To Next Page
Loading...
