Command Line Interface
58 1553-CNH 160 0787 Uen PA2 2005-09-23
11 Command Line Interface
The ECN provides a Command Line Interface (CLI) for management, con-
figuration and line provisioning.
The Command Line can be accessed using a direct connection to the ECN
console port, or through a Telnet connection. The CLI enables configuration
by entering keywords and parameters at a command prompt.
There are two CLI modes: normal operation and fallback state.
The available CLI commands are different in the two modes. The ECN
goes into fallback state, when it fails to start properly. In this mode, the CLI
can be used to check logs and load new software. When the ECN is in fall-
back state, it can be seen in the CLI during login, see
Figure 35 on page
58.
Figure 35 CLI in Fallback State
To Next Page
Loading...
