Command Line Interface
72 1553-CNH 160 0787 Uen PA2 2005-09-23
11.4 Overview of CLI Commands
The CLI commands under normal operation is listed in Table 3 on page 72.
Only the commands on level 1 and 2 are listed.
Table 3 Normal Operation CLI Commands Overview
Level 1 Level 2 Description Page
General
commands -
No level 1
keyword
General commands used for troubleshooting and inspection (end, exit, ping,
restart).
73
Configuration commands for the ECN and embedded nodes. Includes copying
DSL configurations from one port to another.
77
copy-dslport
Copy a DSL-port configuration from one port to an-
other.
78
dslport
Configuration commands for End-user lines. 78
ecn Configuration commands for redundancy and link aggrega-
tion in the ECN.
98
edn Configuration commands for single IP DSLAMs such as link
type configuration.
120
esn
Commands to configure embedded switches. 122
exn Configuration of the EXN104: packet distribution, line-type
and line settings.
125
load-
configuration
Roll back to the last saved configuration. 128
reset-dslports
Reset DSL ports configuration to default. 129
save-
configuration
Save the running configuration. 130
config
system
System configuration. 130
led-test
LED commands. 149
Configuration parameters and information about the network can be displayed
by this command.
150
dslport
Display configuration data for the ADSL line. 150
ecn
Display information of the ECN. 151
edn
Display edn information. 152
show
Exn
Display general and line configuration of the EXN104. 152
To Next Page
Loading...
